膠管近年來，開始采用熱塑性橡膠，如熱塑性聚氨酯橡膠、聚酯橡膠等。膠管因易彎曲、能緩沖、重量輕及安裝使用方便等優點，用途十分廣泛，如農業上排灌農田、港灣疏浚中吸排泥漿，飛機、坦克、汽車及許多機械裝備中的液壓系統、氣動系統、燃油系統均使用許多膠管。氣割操作需要較大的氧氣輸出量，因此與氧氣表高壓端連接的氣瓶（或氧氣管道）閥門應全打開，以便保證提供足夠的流量和穩定的壓力，防止低壓表雖已表示工作壓力，但使用時壓力突然下降，此時容易發生回火，并可能倒燃進入氧氣膠管而引起爆炸。在保存、運輸和使用膠管時必須注意維護，保持膠管的清潔和不受損壞。例如避免陽光照射，雨雪浸淋、防止與酸、堿、油類及其他有機溶劑等影響膠管質量的物質接觸。存放溫度為-15～40℃，距離熱源應不小于1m.如果由于保存和使用時維護不善，或膠管使用日久老化脆硬，這些膠管內的硫磺質被分解出來，常常會因此引起回火爆炸事故。